HP 2910AL - Manual (Page 119)

Switch Memory and Configuration
Using the Menu and Web Browser Interfaces To Implement Configuration Changes
the switch discards the configuration changes made while using the CLI. To
ensure that changes made while using the CLI are saved, execute
write memory
in the CLI before rebooting the switch.
Rebooting from the Menu Interface
■ Terminates the current session and performs a reset of the operating
system
■ Activates any configuration changes that require a reboot
■ Resets statistical counters to zero
(Note that statistical counters can be reset to zero without rebooting the
switch.
To Reboot the switch, use the Reboot Switch option in the Main Menu. (Note
that the Reboot Switch option is not available if you log on in Operator mode;
that is, if you enter an Operator password instead of a manager password at
the password prompt.)
ProCurve Switch 2-Jan-1990 0:00:44
===========================- TELNET - MANAGER MODE -===========================
Main Menu
1. Status and Counters...
2. Switch Configuration...
3. Console Passwords...
4. Event Log
5. Command Line (CLI)
6. Reboot Switch
Optional Reboot
7. Download OS Switch Command
8. Run Setup
9. Stacking...
0. Logout
Provides the menu to display configuration, status, and counters.
To select menu item, press item number, or highlight item and press <Enter>.
Figure 6-5. The Reboot Switch Option in the Main Menu
Rebooting To Activate Configuration Changes. Configuration changes
for most parameters become effective as soon as you save them. However,
you must reboot the switch in order to implement a change in the
Maximum
VLANs to support parameter .
(To access these parameters, go to the Main menu and select 2. Switch
Configuration, then 8. VLAN Menu, then 1. VLAN Support .)
6-11