HP 2910AL - Manual (Page 222)

Port Status and Configuration
Viewing Port Status and Configuring Port Parameters
===========================- TELNET - MANAGER MODE -=============
Switch Configuration - Port/Trunk Settings
Port Type Enabled Mode Flow Ctrl Group Type
---- --------- + ------- ------------ --------- ----- ----
-
1 1000T | Yes Auto-10-100 Disable
2 1000T | Yes Auto-10-100 Disable
3 1000T | Yes Auto Disable
4 1000T | Yes Auto-1000 Disable
5 1000T | Yes 10HDx Disable
6 1000T | Yes 10FDx Disable
7 1000T | Yes 100FDx Disable Trk1 Trunk
8 1000T | Yes Auto Disable Trk2 Trunk
Actions-> Cancel Edit Save Help
Cancel changes and return to previous screen.
Use arrow keys to change action selection and <Enter> to execute action.
Figure 10-2. Example of Port/Trunk Settings with a Trunk Group Configured
2. Press [E] (for Edit). The cursor moves to the Enabled field for the first port.
3. Refer to the online help provided with this screen for further information
on configuration options for these features.
4. When you have finished making changes to the above parameters, press
[Enter], then press [S] (for Save).
CLI: Viewing Port Status and Configuring Port
Parameters
From the CLI, you can configure and view all port parameter settings and view
all port status indicators.
Port Status and Configuration Commands
show interfaces brief page 10-9
show interfaces config page 10-10
show interfaces port-utilization page 10-11
show tech transceivers page 10-12
interface page 10-13
disable/enable page 10-13
speed-duplex page 10-13
10-8