HP 2910AL - Manual (Page 453)

File Transfers
Using USB Autorun
Troubleshooting Autorun Operations
You can verify autorun operations by checking the following items:
USB Auxiliary Port LEDs. The following table shows LED indications on
the Auxiliary Port that allow you to identify the different USB operation states.
Color State Meaning
Green
Green
n/a
Amber
Slow Blinking
Solid
Off
Fast Blinking
Switch is processing USB AutoRun file.
Switch has finished processing USB AutoRun file. This LED
state indicates the AutoRun file was successfully executed,
and the report files were generated. The report files may be
reviewed on a USB-enabled computer for more details. Upon
removal of the USB device, the LED will be turned OFF.
Indicates that no USB device has been inserted, or that a USB
device that cannot be recognized as a USB storage device has
been inserted, or that no AutoRun file can be found on the
inserted USB device. If the USB device has just been removed
from the port, the switch will execute any post commands.
Processing Error. The AutoRun file will stop processing when
an error is encountered (for example, no more disk space is
available on the USB device to write the result and report files).
Remove the USB device and inspect its contents on a USB-
enabled computer for more information on the error.
AutoRun Status Files. The following files are generated during autorun
operations and written to the USB flash drive:
■ Report file(s) (.xml file)—shows which CLI commands have been run.
The file name includes a serial number and datetime stamp to indicate
when and on which device the AutoRun file was executed.
■ Result file(s) (.txt file)—contains the CLI output for each command that
was run on the switch, allowing you to verify whether a command was
executed successfully or not.
N o t e PCM+ provides a mechanism to read these status files and capture the results
of the commands executed. It also allows you to verify the report files for their
authenticity and reject files that have not been signed (refer to the ProCurve
Manager documentation for details).
The status files will not include any records of post commands that may have
been executed after the USB flash drive was removed from the switch.
A-41