HP 2910AL - Manual (Page 450)

File Transfers
Copying Diagnostic Data to a Remote Host, USB Device, PC or UNIX Workstation
These commands copy the Crash Log content to a remote host,
attached USB device, or to a serially connected PC or UNIX
workstation. You can copy individual slot information or the
management module (mm) switch information. If you do not
specify either, the command defaults to the mm data.
For example, to copy the Crash Log for slot C to a file in a PC connected to
the switch:
At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.
Figure A-16. Example of sending a Crash Log for Slot C to a File on an Attached PC
A-38