Need only a quick start, Ip addressing, To set up and install the switch in your network – HP 2910AL User Manual
Page 36: Physical installation, Ip addressing -8, Physical installation -8
Getting Started
Need Only a Quick Start?
Need Only a Quick Start?
IP Addressing
If you just want to give the switch an IP address so that it can communicate
on your network, or if you are not using VLANs, ProCurve recommends that
you use the Switch Setup screen to quickly configure IP addressing. To do so,
do one of the following:
■
Enter
setup at the CLI Manager level prompt.
Procurve# setup
■
In the Main Menu of the Menu interface, select
8. Run Setup
For more on using the Switch Setup screen, see the Installation and Getting
Started Guide
you received with the switch.
To Set Up and Install the Switch in Your
Network
Physical Installation
Use the ProCurve Installation and Getting Started Guide for the following:
■
Notes, cautions, and warnings related to installing and using the switch
and its related modules
■
Instructions for physically installing the switch in your network
■
Quickly assigning an IP address and subnet mask, set a Manager pass
word, and (optionally) configure other basic features.
■
Interpreting LED behavior.
For the latest version of the Installation and Getting Started Guide for your
switch, refer to “Getting Documentation From the Web” on page 1-6.
1-8