HP 2910AL - Manual (Page 363)

Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
The show sflow agent command displays read-only switch agent information.
The version information shows the sFlow version, MIB support and software
versions; the agent address is typically the ip address of the first vlan config­
ured on the switch
.
ProCurve# show sflow agent
Version 1.3;HP;W.14.XX
Agent Address 10.0.10.228
Figure 14-14. Example of Viewing sFlow Agent Information
The show sflow <instance> destination command includes information about
the management-station’s destination address, receiver port, and owner.
ProCurve# show sflow 2 destination
Destination Instance 2
sflow Enabled
Datagrams Sent 221
Destination Address 10.0.10.41
Receiver Port 6343
Owner Administrator, CLI-owned, Instance 2
Timeout (seconds) 99995530
Max Datagram Size 1400
Datagram Version Support 5
Figure 14-15. Example of Viewing sFlow Destination Information
Note the following details:
■ Destination Address remains blank unless it has been configured.
■ Datagrams Sent shows the number of datagrams sent by the switch
agent to the management station since the switch agent was last
enabled.
■ Timeout displays the number of seconds remaining before the switch
agent will automatically disable sFlow (this is set by the management
station and decrements with time).
■ Max Datagram Size shows the currently set value (typically a
default value, but this can also be set by the management station).
14-35