HP 2910AL - Manual (Page 262)

Power Over Ethernet (PoE+) Operation
Configuring PoE Operation
ProCurve(config)# show power-over-ethernet 6
Status and Counters - Port Power Status for port 6
Power Enable
Priority
AllocateBy
Detection Status
: Yes
: low
: value
: Delivering
LLDP Detect
Configured Type
Value
Power Class
: enabled
:
: 15
: 0
Over Current Cnt
Power Denied Cnt : 0
: 0 MPS Absent Cnt
Short Cnt : 0
: 0
Voltage
Power : 55.1 V
: 19.1 W Current : 348 mA
Figure 11-1. Example Displaying PoE Allocation by Value
If you set the PoE maximum value to less than the PD requires, a fault occurs.
ProCurve(config)# int 7 PoE-value 4
ProCurve(config)# show power-over-ethernet 7
Status and Counters - Port Power Status for port 7
Power Enable : Yes
LLDP Detect : enabled
Priority : low Configured Type :
AllocateBy : value Value : 4
Detection Status : Other Fault Power Class : 0
Over Current Cnt
Power Denied Cnt : 0
: 2 MPS Absent Cnt
Short Cnt : 0
: 0
Voltage
Power
: 0
: 0 V
W Current : 0 mA
Figure 11-2. Example Showing PoE Power Value Set Too Low for the PD
11-12