HP 2910AL - Manual (Page 225)

Port Status and Configuration
Viewing Port Status and Configuring Port Parameters
Dynamically updates
Figure 10-5. Example of show int display Command with Dynamically Updating Output
Viewing Port Utilization Statistics
Use the show interface port-utilization command to view a real-time rate display
for all ports on the switch. The following shows a sample output from this
command.
ProCurve(config)# show interfaces port-utilization
Status and Counters - Port Utilization
Rx Tx
Port Mode | --------------------------- | ---------------------------
| Kbits/sec Pkts/sec Util | Kbits/sec Pkts/sec Util
--------- -------- + ---------- ---------- ----- + ---------- ---------- -----
1 1000FDx | 0 0 0 | 0 0 0
2 1000FDx | 0 0 0 | 0 0 0
3 1000FDx | 0 0 0 | 0 0 0
4 1000FDx | 0 0 0 | 0 0 0
5 1000FDx | 0 0 0 | 0 0 0
6 1000FDx | 0 0 0 | 0 0 0
7 100FDx | 624 86 00.62 | 496 0 00.49
Figure 10-6. Example of a Show Interface Port-Utilization Command Listing
10-11