HP 2910AL - Manual (Page 172)

Configuring IP Addressing
IP Configuration
N o t e The default IP address setting for the DEFAULT_VLAN is DHCP/Bootp. On
additional VLANs you create, the default IP address setting is Disabled.
Syntax: [ no ] vlan < vlan-id > ip address <ip-address/mask-length>
or
[ no ] vlan < vlan-id > ip address < ip-address > < mask-bits >
or
vlan < vlan-id > ip address dhcp-bootp
This example configures IP addressing on the default VLAN with the subnet
mask specified in mask bits.
ProCurve (config)# vlan 1 ip address 10.28.227.103 255.255.255.0
This example configures the same IP addressing as the preceding example,
but specifies the subnet mask by mask length.
ProCurve(config)# vlan 1 ip address 10.28.227.103/24
This example deletes an IP address configured in VLAN 1.
ProCurve (config) no vlan 1 ip address 10.28.227.103/24
Configure Multiple IP Addresses on a VLAN (Multinetting). The fol­
lowing is supported:
■ Up to 2048 IP addresses for the switch
■ Up to 32 IP addresses for the same VLAN
■ Up to 256 IP VLANs, that is, VLANs on which you can configure IP
addresses
■ Each IP address on a VLAN must be for a separate subnet, whether on the
same VLAN or different VLANs.
Syntax: [ no ] vlan < vlan-id > ip address < ip-address/mask-length >
[ no ] vlan < vlan-id > ip address < ip-address > < mask-bits >
For example, if you wanted to multinet VLAN_20 (VID = 20) with the IP
addresses shown below, you would perform steps similar to the following.
(For this example, assume that the first IP address is already configured.)
IP Address VID IP Address Subnet Mask
1st address 20 10.25.33.101 255.255.240.0
2nd address 20 10.26.33.101 255.255.240.0
3rd address 20 10.27.33.101 255.255.240.0
8-8