HP 2910AL - Manual (Page 561)

Troubleshooting
Viewing Switch Configuration and Operation
Syntax: copy <source> show- tech
tftp config < startup-config | running-config > < ip-addr > < remote-file >
< pc | unix >
Downloads the contents of a configuration file from a
remote host to
show tech command output, where:
ip-addr: Specifies the IP address of the remote host device.
remote-file: Specifies the pathname on the remote host for
the configuration file whose contents you want to include
in the command output.
pc | unix: Specifies whether the remote host is a DOS-based
PC or UNIX workstation.
For more information on using copy tftp commands, refer
to the “File Transfers” appendix.
.
Syntax: copy <source> show- tech
usb config < startup-config < filename > | command-file < acl­
filename.txt >
Copies the contents of a configuration file or ACL
command file from a USB flash drive to
show tech
command output, where:
startup-config <filename >: Specifies the name of a startup
configuration file on the USB drive.
command-file <acl-filename.txt >: Specifies the name of an
ACL command file on the USB drive.
For more information on using copy usb commands, refer
to the “File Transfers” appendix.
xmodem config < startup-config | config < filename > | command-file
< acl-filename.txt > < pc | unix >
C-73