HP 2910AL - Manual (Page 275)

Power Over Ethernet (PoE+) Operation
Displaying the Global PoE Status
For example, if you wanted to view the PoE status of ports 6 and 7, you would
use
show power-over-ethernet 6-7 to display the data:
ProCurve(config)# show power-over-ethernet 6-7
Status and Counters - Port Power Status for port 6
Power Enable : Yes
LLDP Detect : enabled
Priority : low Configured Type :
AllocateBy : value Value : 17 W
Detection Status : Delivering Power Class : 0
Over Current Cnt : 0 MPS Absent Cnt : 0
Power Denied Cnt : 0 Short Cnt : 0
Voltage : 55.1 V Current : 348 mA
Power : 15 W
Status and Counters - Port Power Status for port 7
Power Enable : yes
LLDP Detect : disabled
Priority : low Configured Type :
AllocateBy : value Value : 17 W
Detection Status : Searching Power Class : 0
Over Current Cnt : 0 MPS Absent Cnt : 0
Power Denied Cnt : 0 Short Cnt : 0
Voltage : 0 V Current : 0 mA
Power : 0 W
Figure 11-9. Example of Show Power-Over-Ethernet < port-list > Output
11-25