Guardian Technologies Ademco VISTA-40 - Manual (Page 120)

Р 6 Р
If you do not wish to enroll the zone displayed, press the # key on the
keypad or the upper right-hand button on the program tool (a long beep will
be heard to verify). The following prompt will appear:
10 LEARN S/N?
0 = NO, 1 = YES 0
To enroll now, enter "1" (YES). If "0" (NO) is entered, the following prompt
will appear :
E NTE R ZN NUM.
(0 0 = Q UIT) 1 2
Zone Number Entered ↑
Enter the next zone number to be enrolled (e.g., zone 12). The system will
search for that zone and will display the prompt shown in the beginning of
step 5. If you wish to exit the enrollment mode completely, enter 00 and
press [
✱ ].
10 INPUT S/N
A 022-4064
↑
Serial #
The system will enroll the first serial number heard, display the serial
numbers, and cause the keypad to beep twice.
If the serial and loop number combination is already present in the system,
the keypad will sound a single long beep and display the word "DUPLICATE"
along with the serial number, and the number of the zone containing the
serial/loop number combination.
7. The system will then enter an optional confirmation mode so that the
operation of the actual programmed input can be confirmed. Activate the
loop input or button that corresponds to this zone. We recommend
that you confirm the programming of every device before
proceeding to the next zone.
10 CONFIRMED SL:1
A022-4064
3
When the system sees activity on the appropriate input, it will beep three
times and display the confirmation message. Press [
✱ ] or the upper left-
hand button of the program tool when you are ready to enroll the next
serial number device.
At any time during this step, you may press the [ ✱ ] key on the keypad or the
upper left-hand button of the program tool if you are satisfied with the serial
and loop number combination that has been enrolled, regardless of whether
or not the enrolled input has been "confirmed." This will ready the system to
enroll the next serial number device.
If the incorrect device has been enrolled, press the # key on the keypad or
the upper right-hand button of the program tool to delete the serial number
and return to the "LEARN S/N" prompt. A single long beep will be heard from
the keypad to verify pressing of the upper right-hand button. Then, press "1"
(Yes) or press the upper left-hand button of the program tool (a single short
beep will verify the system is ready for enrolling) and re-activate the proper
device or device loop input.