Guardian Technologies Ademco VISTA-40 - Manual (Page 69)

Р 69 Р
Programming The Vim For
Relay Triggering On
Supervision Fault
To program the system to trigger a relay upon an VIM fault, use the Relay
Programming Menu (as described earlier) but enter the following values at the
appropriate prompts. When programmed, the relay activates upon VIM failure and
deactivates when the operation of the VIM is restored.
0 2 START EVENT
TROUBLE 3
Enter 3 (trouble) as the event code to start the relay
action.
0 2 START: ZN TYPE
Enter the start zone type code 64 (VIM Fail).
Program the other Relay Programming prompts as you normally would.
Relay Voice Descriptors For each of the 8 relays/X-10 modules used in the system, a voice descriptor can
be programmed. This descriptor will be annunciated by the phone module when
performing the #70 relay commands via telephone.
Each voice descriptor can consist of up to 3 words selected from the relay voice
descriptor vocabulary list shown below. Important: The index numbers from this
vocabulary list are to be used for relay voice descriptors only. For normal system
voice annunciation (e.g., alarms, troubles, status), use the highlighted words in
the alpha vocabulary list found in the alpha programming section.
RLY VOICE DESCR?
0=NO 1=YES
Press 1 to program voice descriptors for relays.
ENTER RELAY NO.
00=QUIT 01
Enter the 2-digit relay/X-10 module number (01-08)
for the relay desired, or enter 00 to quit relay voice
descriptor programming mode. Press [*] to accept
entry.
01 ENTER DESC d1
From the relay voice descriptor vocabulary list, enter
the 3-digit index number for the first word of the relay
descriptor phrase. Press [*] to accept entry.
01 ENTER DESC d2
From the relay voice descriptor vocabulary list, enter
the 3-digit index number for the second word of the
relay descriptor phrase. If second word is not
desired, press 000. Press [*] to accept entry.
01 ENTER DESC d3
From the relay voice descriptor vocabulary list, enter
the 3-digit index number for the third word of the
relay descriptor phrase. If third word is not desired,
press 000. Press [*] to accept entry.
The ENTER RELAY NO. prompt will appear. Enter
the next relay number to be programmed, or enter
00 to quit.