Guardian Technologies Ademco VISTA-40 - Manual (Page 93)

Р 93 Р
Part. 2 Ð SHOP ?
0 = NO , 1 = YES Press 0 (NO) or 1 (YES), depending on whether or
not this user will have access to the displayed
partition number. If NO, the keypad displays this
prompt for the next partition number in sequence.
If YES, the keypad prompts for the following:
¥ UserÕs authority level in the displayed partition (see
Authority Level prompt above). Note that the user
number in the displayed partition is automatically
assigned.
¥ Open/Close option for this user in the displayed
partition (see Open/Close prompt above).
¥ Global Arm option for this user in the displayed
partition.
When both partitions have been displayed, the
keypad will scroll through the partition(s) to which
access has been assigned, and will display the user
number, authority level, open/close and global arm
options that were programmed for each partition the
user was granted access. For example:
Part. 1 S WHSE
User 03 Auth=3G. Note that the ÒGÓ following the authority level
indicates that the global arm feature is enabled for
this user in the displayed partition, and that the
period at the end of the second line indicates
open/close reporting is enabled for this user in the
displayed partition. The "
S " indicates the partition
from which the user may be changed or deleted.
To CHANGE a Master,
Manager or Operator code
Enter Installer code + [8] + User number (02-69) + new code for that user.
The system will detect that the user number is already assigned and will prompt if
this is a new user. Press 0 (NO).
The system will then confirm that the change is allowed based on authorization
level. If the user number is the same as the Installer's, the system will prompt for
the new code to be reentered. This prevents accidentally changing a high level
code.
Or Master or Manager code, but must be code with higher level of authority than the
code being changed. (i.e. Master code can change a Manager or Operator level code,
but cannot change another Master code; a Manager code can change an Operator level
code, but cannot change a Master or another Manager code).
To DELETE a Master,
Manager or Operator code
Enter Installer code + [8] + User number (02-69) + Installer code
The system will prompt if this code should be deleted. Press 0 (NO) or 1 (YES).
If yes, that user's code will be removed from all partitions to which it had been
assigned, and all authorization levels and other information about that user will be
deleted. Note that a user can only be deleted from the partition in which it was first
assigned, and can only be deleted by a user with a higher authority level. A user
cannot delete himself.
Or Master or Manager code, but must be code with higher level of authority than the
code being deleted. (i.e. Master code can delete a Manager or Operator level code, but
cannot delete another Master code; a Manager code can delete an Operator level code,
but cannot delete a Master or another Manager code).
To EXIT The User Code
Entry Mode
Press either [*] or [#], or don't press any key for 10 seconds.