Guardian Technologies Ademco VISTA-40 - Manual (Page 92)

Р 92 Р
To ADD a Master, Manager
or Operator code
Installer must program
a t l e a s t o n e M a s t e r
c o d e .
Important!: During user code entry, normal key depressions at other keypads in
a partition will be ignored. However, panic key depression will cause an alarm and
terminate user entry.
Note: User codes cannot be added by using the Phone Module. User codes
must be added by using an alpha keypad only.
Enter Installer Code + [8] + new User # (02-69) + new User's code
Keypad will prompt for the Authority Level for this user.
Or Master or Manager code,
but must be code with higher
level of authority than the
code being changed. (i.e.
Master code can add a
Manager or Operator level
code, but cannot add
another Master code; a
Manager code can add an
Operator level code, but
cannot add a Master or
another Manager code). User Number = 03
Enter Auth.Level Enter the level number as follows:
1 = Master (Arm, Disarm, Bypass, add or modify lower
level users)
2 = Manager (Arm, Disarm, Bypass, add or modify lower
level users)
3 = Operator Level A (Arm, Disarm, Bypass)
4 = Operator Level B ( Arm, Disarm)
5 = Operator Level C ( Arm, Disarm only if system armed
with this code)
6 = Duress (Arm, Disarm, triggers silent panic alarm)
Keypad will then prompt for Open/Close reporting
option for this user.
Open/Close Rep.?
0 = NO , 1 = YES
Press 0 (NO) or 1 (YES), depending on whether or
not arming/disarming by this user will trigger opening
& closing reports. This prompt appears only if the
installer code is used to add a user.
RF Button ?
0=NO , 1=YES If a 5800 series button transmitter has been enabled,
and not assigned to a user, this prompt will appear.
Enter Button ZN #
(01-63) If yes was given as the answer to the RF button
question, the zone number for the button will be
requested. Enter one of the zone numbers
assigned to the button transmitter as AWAY, STAY
or DISARM. The system will then assign any STAY,
AWAY or DISARM buttons of the transmitter to this
user number.
Multi-Access ?
0 = NO , 1 = YES Press 0 (NO) or 1 (YES). If NO, the program exits this
mode. If yes, the Keypad prompts for the Global Arm
option for this user.
Global Arm ?
0 = NO , 1 = YES Press 0 (NO) or 1 (YES), depending on whether or
not this user will be allowed to arm more than one
partition via Global Arm prompts (described in the
KEYPAD FUNCTIONS section) .
If the Multi-Access option was selected for this user,
the keypad now prompts for the userÕs access to the
next partition.