Microtest TSB-67 - 568A Annex E - Manual (Page 13)

Page 13
Use the Modular 8 Adapter to attach the PentaScanner+ to the user cable attached to the cross
connect. At the other end of the link, use an additional Modular 8 Adapter to attach the 2-Way
Injector+ or Super Injector+ to the user cable attached to the Modular 8 jack.
If you are using a 2-Way Injector or Super Injector with a Modular 8 connector, attach the user cable
directly to the Modular 8 jack, as shown:
If you are using a PentaScanner or PentaScanner Cable Admin and 2-Way Injector or Super Injector
with Modular 8 connectors, attach the user cables directly to the Modular 8 jacks, as shown below:
Wiring Closet Work Area
Modular 8 Jack
Modular 8 Injector 36-Pin Scanner
110 block
User Cable
Chapter 3: Autotest
Autotest lets you run cable tests, check test results against standards, and get a PASS/FAIL
indication — without having to know which tests to select or how to interpret results. Autotest can
be customized depending on your site or system requirements. For example, your system may
require the use of two wire pairs (instead of four) or you may not need to perform all of the tests
that Autotest can run. By customizing Autotest to meet your specific needs, you save time and
money!
Autotest varies depending on your network type. Autotest supports many network types, including
ARCNET, 10BASE-T, Category 5, Category 4 and Category 3 LINK, ISO Class C and D, Token
Ring 4/16 Mbps. See Appendix A: Specifications for a list of supported network types.
Wiring Closet Work Area
Modular 8 Jack
Modular 8 Injector 36-Pin Scanner
Modular 8
Adapter
110 block
User Cable