Customizing autotest, Editing autotest information, Editing the autotest name – Microtest TSB-67 - 568A Annex E User Manual
Page 16
After calculating the NVP, press
Save (F1)
from the
EDIT CABLE
screen to store the new
settings. Then, press
Default (F1)
from the
CABLE SETUP
screen to select the cable as the
default cable type.
Customizing Autotest
To display the
AUTOTEST SETUP
screen, press the
Extended Functions
key, then
select
Setup Autotest
. This screen lets you set the default Autotest, edit Autotest settings and delete
user-defined Autotests.
Press the
Ñ
or
Ò
arrow key to scroll through the list. Or, press the
Ï
or
Ð
arrow
key to scroll up or down one screen at a time. When the Autotest you want to use is highlighted,
press
Default (F1)
to select it as the Autotest to run.
If your Scanner has an alphanumeric overlay on the keypad, use the keypad to change the Autotest
name. If your Scanner does not have an alphanumeric overlay, press
Edit (F2)
to edit the name. See
Chapter 4: Editing, Printing & Updating
for more information on editing. Press
Change (F2)
to set the Margin Display.
Press
Delete (F3)
to delete user-defined Autotests.
Press the
ESCAPE
key to exit.
Editing Autotest Information
To display the
EDIT AUTOTEST
screen, press the
Extended Functions
key, then
select Setup
Autotest
, then highlight the Autotest to edit, then press
Edit (F2).
This screen lets you customize
Autotest settings.
Press the
Ñ
or
Ò
arrow key to scroll through the available options and press
Select (F1)
to choose
the highlighted option. Or, press the number on the keypad that corresponds to the option you
want.
Select
Name/Options
to edit the Autotest name and to change the
MARGIN OPTION
. Select
Pairs
to choose the pairs to be used in the Autotest, and to indicate which pairs have PASS/FAIL
criteria applied to them during Autotest. Select
Tests to Run
to choose which tests to run during
Autotest. Select
Limits
to edit test limits.
Press the
ESCAPE
key to exit.
Editing the Autotest Name
To display the
EDIT AUTOTEST NAME
screen, press the
Extended Functions
key, then select
Setup Autotests
, then highlight the Autotest to edit, then press
Edit (F2),
then select
Name/Options
. This screen lets you edit the Autotest name and change the
MARGIN OPTION
.
If your Scanner has an alphanumeric overlay on the keypad, use the keypad to enter up to 14
characters for the Autotest name. If your Scanner does not have an alphanumeric overlay, press
Edit (F2)
to display the edit screen. See Chapter 4: Editing, Printing & Updating for more
information on editing.