Miller Electric Welder - Manual (Page 102)

OM-196 188 Page 96
1 Setup Pendant Display
Default display when unit is first
turned On, at other times use mode
select button to select Process.
Go to Section 11-3.
1
> Process
Sequence
SharpArc
Card
> Process
Sequence
SharpArc
Card
> Process
Sequence
SharpArc
Card
Prg 1
> MIG
11-2. Changing To Mig Welding
Mode
Select
Parameter
Select
Increase/
Decrease
> Prg 1
AdaptPulse
035” Steel
Argon – Oxy
Prg 1
> AdaptPulse
035” Steel
Argon – Oxy
1 Setup Pendant Display
When unit is turned On, Process is
the default mode. Use mode select
button to select Sequence.
2 Parameter Select Button
Use parameter select button to
select parameters.
3 Preflow Parameters Display
Preflow can be adjusted from 0-9.9
seconds. If value set is zero (0),
there is no Preflow sequence.
Go to Section 11-4.
3
Preflow
> 0.0 Sec
> Preflow
1.2 Sec
2
Process
> Sequence
SharpArc
Card
1
>Process
Sequence
SharpArc
Card
> Prg 1
MIG
>Preflow
0.0 Sec
11-3. Setting Preflow Sequence Display
Mode
Select
Parameter
Select
Increase/Decrease
Parameter
Select
Set Desired Time
Increase
Proceed to next Section