Miller Electric Welder - Manual (Page 105)

OM-196 188 Page 99
1 Postflow Parameters Display
Postflow can be adjusted from
0-9.9 seconds. If value set is zero
(0), there is no Postflow sequence.
1
> Poflw
0.0 Sec
Poflw
> 0.0 Sec
> Poflw
1.2 Sec
11-8. Setting Postflow Sequence Display
Set Desired Time Parameter
Select
Increase/
Decrease
Parameter
Select
.
Run-in parameters are not
global across multiple
programs; instead, run-in wire
speed is local at the run-in
program level.
1 Run-in Parameters Display
Runin can be turned On or Off.
Runin is a function of wire feed
speed only. This is the speed at
which wire feeds until an arc is
established.
IPM 25-780 (0.6-19.8 mpm).
The voltage setting will be the same
as Start sequence if time is set in
that sequence; otherwise, this
sequence will use the welding
power source voltage setting.
1
> Runin
ON
100 IPM
Runin
> ON
100 IPM
Runin
ON
> 120 IPM
11-9. Setting Run-in Sequence Display
Set ON or OFF Parameter
Select
Increase/
Decrease
Parameter
Select
Set Desired Speed
Increase/
Decrease
> Runin
ON
120 IPM
Parameter
Select