Miller Electric Welder - Manual (Page 125)

OM-196 188 Page 119
SECTION 15 – CONTROL MENU
The control menu allows the user access to rise time setting that controls rise and fall time of the pulse square wave.
Changing the rise time setting changes the square wave shape by rounding off the corners, and makes it possible to
quiet the pulse arc by just changing the rise time.
1 Front Panel Control Display
Front panel display during control
setting.
2 Setup Pendant Increase And
Decrease Buttons
3 Power Switch On Front Panel
Press and hold down both buttons
while turning On unit. Release
buttons when Control appears on
the front panel display.
4 Setup Pendant Control
Display
Follow this procedure any time
access is required. To save any
changes made while in the control
display, and/or to exit the control
display, cycle power off and back
on at power switch.
2
> Rise Time
Adaptive
AutoConfig
Retract
3
4
Increase
Button
Decrease
Button
15-1. Using Menu Display
Pulse Panel Display
1
C o n t r o l
Front Panel Display
A/ms
> 800