1. routine maintenance, 2. blowing out inside of unit – Miller Electric Welder User Manual
Page 31
Advertising
OM-196 188 Page 25
SECTION 5 – MAINTENANCE & TROUBLESHOOTING
5-1.
Routine Maintenance
Y
Disconnect power
before maintaining.
.
Maintain more often
during severe conditions.
3 Months
Replace
damaged or
unreadable
label.
Repair or
replace
cracked
cables.
Replace
cracked
torch body.
Repair or
replace cracked
cables and cords.
6 Months
Clean and
tighten weld
terminals.
Blow out
inside.
5-2.
Blowing Out Inside Of Unit
Y
Do not remove case when
blowing out inside of unit.
To blow out unit, direct airflow
through front and back louvers as
shown.
801 914
Advertising