Miller Electric Welder - Manual (Page 112)

OM-196 188 Page 106
13-7. Selecting Security Lock
Security lock works only when a data card is inserted.
NOTE
1 Security Display
Use this display to lock a program’s
weld parameters so that changes
can not be made using pulse panel
controls.
2 Program Number
Choose the program number (1
through 8) to be locked.
3 Program Lock Display
When lock is off a program, the
operator can change all weld
parameters of that program without
restriction.
With lock on a program, the
operator cannot change
parameters of that program.
> Prog 2
Lock Off
> Prog 1
Lock Off
Prog 2
> Lock Off
Prog 2
> Lock On
1 2
3
> Prog 2
Lock On
> Prog 3
Lock Off
Press Mode
Select
Increase Parameter
Select
Increase
Access
Setup
Display
Parameter
Select
Increase
Sequence
SharpArc
Card
> Security