Miller Electric Welder - Manual (Page 115)

OM-196 188 Page 109
14-3. Selecting Or Changing Access Code
Access code works only when a data card is inserted (see Section 13).
NOTE
1 Code Display
With code off, access to the setup
displays is not restricted.
With code on, the operator must
know and enter the access code to
access or change any of the setup
displays.
2 Access Display
With a code set, this display
appears when power is turned on
while holding the pulse panel Mode
and Parameter Select buttons.
Press Parameter Select button to
enter access code. When the
correct letter is entered, the
indicator automatically moves to
the next character. When the final
access code letter is entered, the
display automatically changes to
the initial setup display.
1
>Access
Mig Type
Aux Out
Voltage
Code
> Off
Code
> On
AAA
Code
On
> AAA
⇒
Press
Code
On
> ZWX
⇒
Press
Enter
Access
Code > Code AAA
⇒
Press
2
Press Mode
Select
Parameter
Select
Increase/Decrease
To Set Code
Access
Setup
Display
Increase
Parameter Select
To Move Indicator
Turn Power Off And Back On
And Access Security Display