2. using setup displays – Miller Electric Welder User Manual
Page 114
Advertising
OM-196 188 Page 108
1
Front Panel Setup Display
Front panel display during setup.
2
Pulse Panel Mode And
Parameter Select Buttons
3
Power Switch On Rear Panel
Press and hold down both buttons
while turning On unit.
4
Setup Pendant Display
Follow this procedure any time
access is required. Once in the set-
up displays, use the Mode Select
button to select a particular display.
To save any or all of the changes
made while in the setup displays,
and/or to exit the setup displays,
turn power to the unit Off and back
On.
14-2. Using Setup Displays
1
2
Access
Mig Type
Aux Out
Voltage
> Volt Min
10.0 Volt
3
S e t u p
4
Mode
Select
Parameter
Select
Front Panel Display
Setup Pendant Display
Advertising