JVC BD-X201MS - Manual (Page 21)

E-21
Preparation
Connections
Audio and video signals
Note 1: The video signal for input is selected using INPUT SELECT from the INPUT SELECT MENU screen.
Note 2: The audio signals for input are selected using INPUT SELECT from the INPUT SELECT MENU screen.
When either LINE or Y/C is set for INPUT SELECT, the analog audio signals from the AUDIO IN terminals will be
selected for input.
When DV is set for INPUT SELECT, the DV audio signals from the DV IN/OUT terminal will be selected for input.
Note 3: When the DVD recorder is in Stop or Recording mode, the video input signal is output on the E-E screen as a composite
video signal.
In addition, the Setup Menu and other setting screens are also displayed on the monitor connected to this terminal. The
DVD recorder’s operation status and other relevant information are displayed on-screen when DISPLAY from the DIS-
PLAY MENU screen has been set to ON.
Note 4: The Y/C IN/OUT terminal’s specification (i.e., S1 or S2) can be selected using Y/C TERMINAL MODE from the SYS-
TEM MENU (2/2) screen. The same information as with the VIDEO LINE OUT terminal is output from the Y/C OUT ter-
minal.
Note 5: The standard input level for audio signals input via the AUDIO IN terminals (i.e., +4 dB or –8 dB) can be selected using
the AUDIO INPUT LEVEL switch on the rear panel.
Note 6: Use the following cable as the DV cable.
VC-VDV204 (2m, 4P-4P) from JVC
VC-VDV206 (2m, 4P-6P) from JVC
DV IN/OUT
DV IN/OUT Y/C IN
Y/C OUT
LINE IN
LINE OUT
AUDIO OUT
AUDIO IN
RS-232C
REMOTE
DV
DV
USB
REMOTE
Audio output
Input
Note 2
PHONES
(on front panel)
Note 6
Note 4
REMOTE cable
Input
Note 5
YC separate
Note 3
Note 4
Video output
YC separate
Analog audio
Composite
Composite
Stereo
Headphones
Monitor TV
Keyboard
Analog audio
Note 1