Strahl D1600mkII - Manual (Page 107)

99
COUNTER
Reference
SYSTEM /
USB
RECORD
TRACK
SONG /
CD
STORE
MARK
SCENE
TEMPO / RHYTHM
IN / LOC1... END / LOC4
AUTO PUNCH
LOOP
UNDO
TRIGGER
SCRUB
ENTER
INPUT / TUNER
EQ / PHASE
INSER
T
FX
MASTER FX / AUX
SOLO / MONITOR
METER / Tr VIEW
Tr
ST
ATUS
PA
N
FADER
TRANSPORT
P1 RecMode: Selecting the recording
mode
1. Select RecMode ................................... [Input, Bounce]
Selects the recording mode.
Input
: The input (analog, digital, internal rhythm pat-
tern, CD-R/RW drive) will be recorded. Use the channel
faders to adjust the recording level of each track.
Bounce
: Bounce-recording will be performed. The
master LR bus will be recorded. Use the channel faders
to adjust the playback level of each track, and use the
master fader to set the recording level.
You can apply master effects and a final effect to
multiple tracks while you combine them to two tracks.
Use bounce-recording when you want to master your
song to produce an audio CD.
If “Bounce” is selected, the number of simultaneously-
recorded tracks will always be 2 tracks.
P2 Bounce: Settings for bounce
recording
For the procedure of bounce recording, refer to p.42.
1. Select BounceMode............. [14Tr+2In→2Tr, 16Tr→2Tr]
Select the type of bounce recording.
14Tr+2In→2Tr: Select this when recording 14 tracks of
playback + 2 inputs onto two tracks.
The input sound selected in the [INPUT/TUNER] “Ch1–
8” tab page and “Ch9–16” tab page will be valid for the
channel(s) whose [TRACK STATUS] key is set to REC
(LED lit red), and will be recorded together with the
other playback tracks.
16Tr→2Tr: Select this when recording 16 tracks of play-
back onto two tracks.
The track playback will be valid for the channel(s)
whose [TRACK STATUS] key is set to REC (LED lit red),
and will be recorded together with the other playback
tracks.
Be aware that if “Rhythm” is set to “On” during
bounce recording, the rhythm will also be recorded
together with the other sounds.
2. RecordVirtualTrack .............................. [Current, a…h]
Select the recording destination virtual track.
Select the virtual track of the recording track selected by
the [TRACK STATUS] key on which bounce recording
will occur.
By selecting a virtual track “a”–“h” other than “Cur-
rent,” you can combine tracks 1–16 into two tracks with-
out erasing any of the tracks 1–16.
Current
: The currently selected track
a…h : The specified virtual track
However if the same virtual track is selected both here
and for [TRACK] “Vtr1–8” or “Vtr9–16” tab page the
result will be the same as if “Current” were selected.
To avoid accidentally recording a track that has
already been recorded, use the [TRACK] “Vtr1–8”
and “Vtr9–16” tab pages to see which virtual tracks
are currently selected and which contain data.
3. RECORD
1
1 2
RECORD