Strahl D1600mkII - Manual (Page 130)

122
Scrub, Play From/Play To, and Slow Play functions can be
switched on/off here.
Each time you press the [SCRUB] key, the setting will be
switched on or off.
By using these functions, you can register Locate and Mark
times more precisely and easily.
If you use the Scrub function on a song that uses the
tempo track, you should set the counter display (→p.91)
unit to time display (MSM) or frame display (MSF). If
this is set to MBT, rotating the [VALUE] dial may not
play the data immediately.
You can use the following functions when the [SCRUB] key
is on (lit).
• Scrub function: You can turn the [VALUE] dial to play
back the track data.
Use this when you want to hear the audio while searching
for a specific location in the song. This is somewhat
similar to manually turning an analog record on a
turntable to find the beginning of a song.
• Play From function: When you press the [PLAY] key,
playback will begin from the location at which you are
currently stopped, and will end after two seconds and
automatically return to the point at which playback
began.
• Play To function: When you hold down the [STOP] key
and press the [PLAY] key, playback will begin from a
point two seconds earlier than the location at which you
are currently stopped, and will end at the location at
which you were stopped.
You can use the Play From function and Play To
function to find a location more accurately.
• Slow Play function: When you press the [FF] key, half-
speed playback will begin from the location at which you
are currently stopped. When you press the [STOP] key,
playback will stop and you will return to the location at
which you started.
Since the slow playback will be one octave lower
than the normal pitch, you can use this function
either as-is or in conjunction with the Pitch Shifter
effect to practice rapid phrases that are difficult to
catch by ear.
If this is “On,” the [VALUE] dial will be used for
Scrub playback; this means you will not be able to
use the [VALUE] dial to edit the value of settings.
1. Loc (Locate) ........................................ [000:00.000…]
Change the current time location.
You can rotate the [VALUE] dial to change the current
time location while listening to the sound and viewing
the waveform.
2. TrackSelect.................................................[Trk1…16]
Select the track that will be played and whose waveform
will be displayed.
Press the “ ” button and select from the list.
3. Zoom In/Out/Up/Down.............................................
Adjust the size of the waveform display and the play-
back speed.
: Expand the waveform display vertically.
: Shrink the waveform display vertically.
: Expand the waveform display horizontally.
: Shrink the waveform display horizontally.
By pressing the [ENTER] key, you can finalize a parameter
selection or turn it on/off.
15. SCRUB
1
3
2
16. ENTER