Strahl D1600mkII User Manual
Page 41
33
t
Write to CD-R
When creating an audio CD, the virtual tracks that are currently selected
for tracks 1 and 2 will be used. To verify that the virtual tracks you intend
to write are selected, play back the song or access the [TRACK] “Vtr1–8”
tab page.
1. Insert a blank disc into the CD-R/RW drive.
By “blank disc” we mean an unused CD-R or CD-RW. A CD-RW that
has been used can also be completely erased and used as a blank
disc.
However since CD-RW discs may sometimes not be playable in an
audio CD player, we recommend that you use CD-R discs.
2. Access the [SONG/CD] “CDR/RW” tab page.
Press the “
” button, and in the screen that appears,
press the “OK” button. Make sure that “CD-R/RW Information”
indicates “BlankDisc” or “song number.” The free space on the disc is
displayed below this.
3. Press the “WriteCD” button.
A message of “Obey Copyright Rules” will appear.
4. Select the writing speed.
Select the writing speed that is appropriate for the disc you are using.
For example if the disc you are using is marked as “supports 8x writ-
ing,” you can select the “8x” writing speed. “8x” means that the disc
will be written at eight times the conventional playback speed.
Depending on your system, it may not be possible to write at the
selected speed. If so, try a slower writing speed.
5. Carefully read the owner’s manual section “COPYRIGHT WARN-
ING” (→p.iii), and press the “Yes” button if you accept the terms.
The D1600mkII will begin creating an image file.
You can stop creating the image file by pressing the “Abort” but-
ton during this time.
Then the D1600mkII will start writing the CD.
If you press the “Abort” button while data is being written to the
CD, the writing will stop. If you were writing a CD-R, that disc
will become unusable. If you were writing a CD-RW, you can
erase the entire disc and use it again as a blank disc.
When writing is completed, the display will indicate “Completed”.