Strahl D1600mkII - Manual (Page 18)

10
1. Connections
The diagram below shows a basic example of connec-
tions when using the D1600mkII to record. Make the
appropriate connections for your system, substituting
your own equipment as necessary for the equipment
shown here.
Be sure that the power is turned off while you are
making connections. If the power is on while connec-
tions are being made, your speaker system may be
damaged, or other malfunctions may occur.
1. Connect the included power supply cable.
Connect the power supply cable to the D1600mkII’s
[AC] connector. Then plug the other end into an elec-
trical outlet.
2. Connect your audio monitoring system.
Use a phone cable to connect powered monitors etc.
to the [MONITOR OUT L/R] jacks.
If you will be monitoring through headphones, con-
nect the 1/4" phone plug of your headphones to the
[PHONES] jack.
Use the [PHONES LEVEL] knob to adjust the
volume.
The audio signal that is output from the [MONITOR
OUT L/R] jacks and the [PHONES] jack is set in the
[SOLO/MONITOR] “Monitor” tab page.
3. Connect your input devices.
To record analog signals
• Guitar/bass ↔ [GUITAR IN] jack
• Mic (XLR) ↔ [INPUT 1]–[INPUT 4] jacks
• Synthesizers, etc. ↔ [INPUT 1]–[INPUT 8] jacks
For details on specifying how the input audio signals
are sent to mixer channels, and how to monitor the
input sound, refer to “Assign audio inputs to the
mixer” (→p.36).
A guitar or bass guitar that is being sent through
a compact effect device can be connected to
[INPUT 1]–[INPUT 8].
Preparations
[PHONES LEVEL] knob [PHONES] jack
Master recorder (Digital: DAT, MD, etc.)
PHONES
Keyboard
Guitar
Mic
Headphones
Master recorder (Analog: cassette tape recorder, etc.)
AC connector
S/P DIF IN
DIGITAL IN
INPUT L/R
DIGITAL OUT
S/P DIF OUT
OUTPUT
GUITAR IN
INPUT
1–4
INPUT
1–8
Powered monitors etc.
MIDI
sequencer
MIDI
IN/OUT
MIDI
OUT/IN
MONITOR
OUT L/R
MASTER
OUT L/R
USB
to the AC outlet
Computer