Lucent Technologies MN10285K - Manual (Page 305)

I
2
C Bus Controller
I
2
C Bus Interface Registers
Panasonic Semiconductor Development Company MN102H75K/F75K/85K/F85K LSI User Manual
304
Panasonic
13.7 I
2
C Bus Interface Registers
All registers in I
2
C blook cannot be written by byte (by word only). Read by byte
is possible.
I2CDTRM: I
2
C Transmission Data Register x’007E40’
SCL is held low during interrupt
servicing, and is cleared high by
a write to I2CDTRM.
STA: I 2 C start control
STO: I
2
C stop control
Writing to the STA and STO bits allows you to change the state of the
transmission or reception operation. Table 13-6 shows the settings for dif-
ferent start and stop conditions.
ACK: Acknowledge signal output control
The acknowledge signal is output after every byte transfer, on the ninth
clock pulse. ACK is normally 1 and transitions to 0 to output an acknowl-
edge (for instance if the master or slave receiver has received a data byte).
DT[7:0]: Data to be transmitted
The parallel data in this field is converted to serial data for transmission to
the I
2
C bus. It is shifted out MSB first to the interface.
Bit: 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
— — — — — STA STO ACK DT7 DT6 DT5 DT4 DT3 DT2 DT1 DT0
Reset: 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0
R/W: R R R R R R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W R/W
Table 13-6 STA and STO Settings
STA STO Mode Function Description
0 0 All NOP No state change
1 1 All NOP No state change
1 0 Slave receiver Start Change to mode indicated by R/W bit.
R/W = 0: Change to master transmitter
R/W = 1: Change to master receiver Master transmitter Repeat start
0 1 Slave receiver Stop read Change to slave receiver after stop
condition. Master transmitter Stop write