Lincoln Electric COMMANDER SVM153-A User Manual
Commander 500, Svm153-a, Service manual
Advertising
Table of contents
Document Outline
- Table of Contents
- Safety
- Section A - Installation
- Section B - Operation
- Section C - Accessories
- Section D - Maintenance
- Section E - Theory of Operation
- Section F - Troubleshooting & Repair
- Symptoms
- Major physical or electrical damage is evident.
- No welding output in neither Stick or CV modes. The engine operates normally. The auxiliary output is normal.
- No welding output in neither Stick or CV modes. Also no auxiliary power. The engine operates normally.
- No auxiliary power at the receptacles. The welding output is normal and the engine operates normally.
- The machine has welding output but no control of output. The auxiliary power is normal.
- The machine has low welding output and low auxiliary output.
- The machine control is still active when the remote control unit is attached.
- The machine seems locked into the CC mode of operation (Stick mode).
- The wire feeder does not work when connected to the welder amphenol.
- The battery does not stay charged.
- The engine will not crank when the start button is pushed.
- The engine cranks but will not start.
- The engine shuts down shortly after starting.
- The engine will not idle down to low speed. The machine has normal weld output and auxiliary power.
- The engine will not go to high idle when using the auxiliary power. Auxiliary power is normal when the IDLER switch is in the
- The engine will not go to high idle when attempting to weld or when the auxiliary power is loaded. Welding output and ...
- The machine goes to low idle but does not stay at low idle.
- The welding arc is "cold." The engine runs normally. The auxiliary power is normal.
- Symptoms
- Section G - Electrical Diagrams
- SVM Error Reporting Form