Panasonic DVCPRO50 AJ-D960EG - Manual (Page 19)

ENGLISH
19 (E)
Controls and their functions
<Connector area>
!5
ANALOG COMPONENT VIDEO OUT connector (option)
The analogue component video signal is output from this connector.
!6 ANALOG COMPOSITE VIDEO OUT connectors
The analogue composite video signals are output from these connectors.
The video signal with signals superimposed on it can be output from the VIDEO OUT 3
connector.
The superimpose function can be set ON or OFF on the setup menu No. 007 (SUPER).
!7 DIGITAL AUDIO IN/OUT connector
This I/O connector is for digital audio signals which comply with the AES/EBU standard.
!8
SERIAL DIGITAL COMPONENT AUDIO/VIDEO IN/OUT connector
This I/O connector is for digital component audio and video signals which comply with the
SMPTE 259M-C/272M-A/EBU Tech.3267-E standard.
The SERIAL OUT 3 connector can output the video signal containing superimposed data.
The superimposed data can be set ON/OFF using setup menu No. 007 (SUPER).
<Note>
When the SDTI board (optional accessory) is used, SERIAL IN is used for the SDTI/SDI
common input signal while SERIAL OUT1 is used for the SDTI/SDI common output signal.
For further details, refer to the operating instructions accompanying the model AJ-
YAC960P SDTI interface board.
!9 Remote control connectors
The unit can be controlled from an external source by connecting the unit with another unit
or an external controller.
There are two remote control connectors, one for IN/OUT uses and the other for OUT
uses.
IN/OUT: For connection with an external controller.
For connection with deck-to-deck operation.
OUT: For connection with parallel running operations.
For use in a loop-through configuration.
<Note>
To connect the unit to the OUT connector when performing deck-to-deck operations where
this unit is used as the recorder, selection can be made using setup menu No. 212
(MASTER PORT).
@0 ENCODER REMOTE connector
The external encoder/controller is hooked up to this connector when the video output
signal and other settings are to be adjusted from an external source.
@1
RS-232C connector
@2 PARALLEL REMOTE connector
This is used when operating the unit from an external source.