Panasonic DVCPRO50 AJ-D960EG - Manual (Page 51)

ENGLISH
51 (E)
Multi cue
Entering cue points
The following operations are performed by selecting the setup menu No. 131 (PAGE MODE)
setting.
■ Operations on the selected page (PAGE MODE=MANU)
• The operation is performed on the selected page.
• The page is selected by pressing the ADJ button and the TRIM+ or TRIM– button together.
• By pressing the SET button on its own, the cue points are entered in the following sequence
on the selected page:
CUE
1 ¤ CUE 2 ¤ ... ¤ CUE 7 ¤ CUE 8
(Points already entered are overwritten.)
• When CUE 8 point is entered on the page, the entry operation is automatically ended*.
When the next cue point is to be entered, the entry pointer must be changed.
Check that the entry point display mode is established, and change the page so that the
entry pointer is automatically changed. In this case, the search pointer will also move
automatically to the top (CUE
1) of the changed page. To change the pointer on the same
page, press the CUE button directly.
* A rotation operation is performed on the same page in the following sequence when “ON”
has been selected as the setup menu No. 132 (ROTA MODE) setting:
¤ CUE 1 ¤ CUE 2 ¤ ... ¤ CUE 7 ¤ C
■ Operation for automatically continuing entry onto the next page when the page on
which the cue points are being entered has been filled (PAGE MODE=AUTO)
• When the page on which the cue points are being entered has been filled, entry auto-
matically continues on the next page. Entry is automatically concluded when CUE98 is
entered on the last page.
When the next cue point is to be entered, the entry pointer must be changed.
Check that the entry point display mode is established, and change the page so that the
entry pointer is automatically changed. In this case, the search pointer is not changed.
To change the pointer on the same page, press the CUE button directly.
* If “ON” has been selected as the setup menu No. 132 (ROTA MODE) setting, the rotation
operation moves the page from page 9 (CUE98) to page 0 (CUE01).
When it is no longer possible to enter in either of the above operation modes:
• “
” appears on the entry pointer display, and the “ENT ” display flashes.
• In the entry point display mode, the FULL MEMORY message appears when the entry point
display operation is performed (by pressing the SET button).
• None of the LEDs will flash.
(Operation will be the same as the ones described above even when some of the points in
between have not been entered.)
S R C 0 1 ¤ E N T R 9 0
F U L L M E M O R Y R 9 0
This display flashes.
<Note>
If “ON” has been selected as the setup menu No. 132 (ROTA MODE) setting, entry will not
be disabled.