Panasonic DVCPRO50 AJ-D960EG - Manual (Page 39)

ENGLISH
Automatic editing
39 (E)
POWER
ON
OFF
L
LEVEL CH4 CUE
DVCPRO
AUDIO ANALOG
VIDEO Y PB PR
AES/EBU USER SET
CMPST
INPUT SELECT
SDI
CH CONDITION
SCH CF
SHIFT ADJ START RESET
STAND BY
UB EXT EE
TC INT
TC MODE
TAPE
LOCAL REV FWD
PULL
OPEN
JOG
PUSH
EJECT
AUTO OFF
SHTL
SLOW
CONTROL
REMOTE
EDIT
REW
PLAY
SERVO
STOP
PLAYER
REC
REC INHIBIT
FF
RECORDER
TC/CTL
TC SET
INSERT
CH2
TRIM
SET OUT IN
CH3 CH4 CUE TC
AUTO EDIT PREROLL
PREVIEW
REVIEW
REC
PB
PULL FOR VARIABLE
PULL
OPEN
HEADPHONES
CH1 CH2
R
METER
FULL/FINE
MONITOR SELECT
W
– +
SDI SDTI(V&A)
ASMBL VIDEO CH1
4 5 6 7 3 2 1
A
OUT
A
IN
MULTI CUE
CH3
8
SLOW MOTION
1
Executing automatic editing
1
Press the AUTO EDIT button.
Automatic editing is now performed.
• To stop the editing at any time, press the STOP button.
• When the edit OUT point is reached, the unit goes into the stop mode after
postrolling*.
* The postroll time can be set using setup menu No. 325 (POSTROLL TM).
Postroll
With assemble editing, editing continues for approx. 2 seconds even after the edit OUT point
has been passed, the tape is rewound to the OUT point, and the unit goes into the stop
mode.
With insert editing, the unit goes into the play mode after the edit OUT point has been
passed, the tape is rewound to the OUT point, and the unit goes into the stop mode.
Retry function
If the AUTO EDIT button is pressed again after the STOP button has been pressed to stop
the editing, editing will start again from the beginning.
Auto tag editing
If the AUTO EDIT button is pressed when the next edit point has not yet been entered upon
completion of editing, the previous edit OUT point will be entered as the IN point, and editing
is performed accordingly.
To release the auto tag mode, press one of the tape transport buttons (PLAY, etc.).
<Note>
The entered points are automatically cleared after editing is executed. However, the previous
editing points can be recalled by pressing the TRIM+ (or TRIM–) and SET buttons together.