Panasonic DVCPRO50 AJ-D960EG - Manual (Page 61)

ENGLISH
61 (E)
Setup menus
USER menu
<BASIC>
Item Setting
No.
Superimposed
No.
Superimposed Description
display display
000 P-ROLL 0000 0S
. .
. .
TIME . .
0005 5S
. .
. .
. .
0015 15S
001 LOCAL 0000 DIS
ENA 0001 ST&EJ
0002 ENA
002 TAPE 0000
±
12h
TIMER 0001 24h
003 REMAIN 0000 OFF
SEL 0001 ON
004 SETUP 0000 OFF
NUMBER 0001 ON
005 METER 0000 CUE
SELECT 0001 VIDEO
006 SYNCHRO- 0000 OFF
NIZE 0001 ON
007 SUPER 0000 OFF
0001 ON
0002 SW
The underline on the setting item denotes the initial setting.
This sets the preroll time which can be set from 0 to 15
seconds in 1-second increments.
<Note>
When the unit is set to automatic editing [PREVIEW, AUTO
EDIT], the unit will not operate if the preroll time is set to 0
seconds.
This selects the buttons which can be operated on the front panel
when the REMOTE/LOCAL switch has been set to REMOTE.
0: No buttons can be operated.
1: Only the STOP and EJECT buttons can be operated.
2: All buttons except for the RECORDER and PLAYER
buttons can be operated.
This selects the 12 or 24 hour display for the CTL counter.
0: 12 hour display
1: 24 hour display
This selects whether to indicate the remaining tape time
(REMAIN) on the front panel display and the superimposed
display at the VIDEO OUT 3/SERIAL OUT 3 connectors.
0: Remaining tape time is not displayed.
1: Remaining tape time is displayed.
<Note>
• The remaining tape time is indicated at the far right of the
second line on the front panel display and superimposed
display.
• Even when 1 (ON) has been selected, the remaining tape
time is not displayed while it is being calculated after the
cassette has been ejected or inserted.
• When TIME has been selected as the setup menu item
No. 008 (DISPLAY SEL) setting, the time is not indicated on
the superimposed display.
• No display appears if the freeze mark (F) is indicated by the
setup menu item No. 111 (FRZ MODE SEL) setting.
• No display appears if the tape start or end has been
detected and BOT or EOT is displayed.
This selects whether the SETUP-MENU user file No. is dis-
played on-screen.
0: The SETUP-MENU No. is not displayed.
1: The SETUP-MENU No. is displayed.
This selects whether the level meters are to display the CUE
track signal level or the video signal level.
0: The CUE track signal levels are displayed.
1: The video signal levels are displayed.
This selects whether or not to synchronize between two VTRs.
0: No synchronization. The editing points deviate several
frames, but editing can be started quickly.
1: Synchronization. Allows for error-free editing.
This selects whether the time code and other super display
which are output to the VIDEO OUT 3/SERIAL OUT 3 con-
nector is to shown.
0: Not shown.
1: Shown.
2: ON or OFF for the superimposed display is selected by
pressing the PLAY button while holding down the SET
button on the lower section of the front panel.
<Note>
The regular playback operation is performed if the PLAY
button is pressed first.