Panasonic DVCPRO50 AJ-D960EG - Manual (Page 78)

Setup menus
78 (E)
USER menu
<VIDEO> (continued)
Item Setting
No.
Superimposed
No.
Superimposed Description
display display
618 INTERPOLATE 0000 OFF
0001 AUTO
620 ESR MODE 0000 OFF
0001 AUTO
621 CCR MODE 0000 OFF
0001 ON
640 SDI INDEX 0000 OFF
O 0001 ON
650 SER IN 0000 MANU
MODE 0001 AUTO
652 SER OUT1 0000 SDI
SEL 0001 SDTI
653 SDTI MODE 0000 1X_R
0001 2X_P
The underline on the setting item denotes the initial setting.
Vertical interpolation is conducted automatically during slow-
motion playback to reduce the vertical movement of the play-
back pictures. However, this menu item enables the inter-
polation operation to be forcibly turned off.
0: Interpolation is forcibly turned off.
1: Interpolation is automatically turned on during slow-motion
playback.
This selects the operation mode for edge subcarrier reduction
(ESR) in the playback circuit.
0: The mode is forcibly set to OFF.
1: The mode is automatically set to ON or OFF depending on
the VTR operation.
This selects the cross colour processing during playback.
0: The cross colour is output with no changes made.
1: The cross colour can be reduced.
<Note>
This setup menu is not displayed in the 625 mode.
This selects the operation to the video index (CF and WIDE)
for the serial output.
0: The video index is not added to serial output signal.
1: CF and WIDE information is added to the serial output
signal as the video index.
For selecting the serial input mode.
0: The SDI signal or SDTI signal is automatically selected in
accordance with the serial input signal. The input display
on the front panel is automatically switched in accordance
with the input signal.
1: The same mode is selected as the input mode selected on
the front panel.
For selecting the signal to be output to serial output 1.
0: The SDI signal is output.
1: The SDTI signal is output.
Selects the VTR and SDTI input/output operation when a
DVCPRO50 or DVCPRO tape has been inserted.
0: Normal mode is set.
Recording, playback and SDTI input/output can be
performed at 1
×
speed.
1: 2 × transmission mode is set.
Playback and SDTI output can be performed at 2
×
speed.
<Notes>
• This setup menu’s setting takes effect only when “SDTI” or
“AUTO” has been selected as the setup menu No. 652 (SER
OUT1 SEL) setting. If “SDI” has been selected, the tape will
be recorded and played back at the 1
×
speed regardless of
this setup menu’s setting.
• When “2X_P” has been selected, the tape cannot be played
back at the 1
×
speed.
• If a tape is inserted when “2X_P” has been selected, the
REC INHIBIT lamp lights and recording operations are pro-
hibited. In addition, the VV mode will be established at all
times, and the EE pictures will not be output.
• When a DV or DVCAM tape has been inserted, it is played
back at the 1
×
speed regardless of this setup menu’s setting.
<Note>
If the optional SDTI inter-
face board (model AJ-
YAC960P) has not been
installed, setup menus
No. 650, 652 and 653
will not be displayed.