Panasonic DVCPRO50 AJ-D960EG - Manual (Page 72)

Setup menus
72 (E)
USER menu
<EDIT> (continued)
Item Setting
No.
Superimposed
No.
Superimposed Description
display display
317 AUD MEM 0000 OFF
MODE 0001 AMU_X
0002 AMU_VO
0003 INT_X
0004 INT_VO
318 AUD MEM 0000 CH1
CH 0001 CH2
0002 CH3
0003 CH4
320 VAR FWD 0000 +4.1
MAX 0001 +2
0002 +1
321 VAR REV 0000 –4.1
MAX 0001 –2
0002 –1
The underline on the setting item denotes the initial setting.
Establishes the setting for voice-over and/or audio cross
channel editing using the AJ-YA752 audio memory unit or
built-in audio memory.
0: Neither voice-over nor audio cross channel editing is
performed.
1: Audio cross channel editing is performed using the AJ-
YA752 audio memory unit.
2: Voice-over editing is performed using the AJ-YA752 audio
memory unit.
3: Audio cross channel editing is performed using the internal
audio memory.
4: Voice-over editing is performed using the internal audio
memory.
<Notes>
• The RS-232C interface will not function with the 1 (AMU_X)
or 2 (AMU_VO) setting.
• When the 2 (AMU_VO) or 4 (INT_VO) setting is selected,
the channels selected by the setup menu item No. 318 (AUD
MEM CH) setting are output to the monitor with any delay
automatically eliminated internally using the CUE system.
Consequently, CUE audio no longer functions, and the setup
menu item No. 726 (REC CUE) also loses its function since
this is now automatically switched internally.
Up to 20 seconds of sound can be stored in the unit’s
internal memory. It should be borne in mind that even if an
attempt is made to store more than 20 seconds of sound in
the memory, all the audio signals in excess of the memory’s
20-second capacity will fail to be stored.
• Refer to the instruction manual of the AJ-YA752 audio
memory unit for details on how to use each mode using this
unit.
This sets the channel for the voice-over or audio cross
channel editing which is performed using the AJ-YA752 audio
memory unit or internal audio memory.
0: The signals are recorded onto CH1.
1: The signals are recorded onto CH2.
2: The signals are recorded onto CH3.
3: The signals are recorded onto CH4.
<Note>
This setting has no effect when AMU_VO has been selected
as the setup menu No. 317 (AUD MEM MODE) setting.
This sets the maximum VAR FWD speed.
0: +4.1 (+3.1)
×
speed
1: +2 (+1.85)
×
speed
2: +1
×
speed
<Notes>
• The value for the DV/DVCAM format is shown in parenthesis
( ).
• At any speed setting other than 0 (+4.1
×
), the phase cannot
be synchronized from the editing controller.
This sets the maximum VAR REV speed.
0: –4.1 (–3.1)
×
speed
1: –2 (–1.85)
×
speed
2: –1
×
speed
<Note>
The value for the DV/DVCAM format is shown in parenthesis
( ).