Overland Storage REO 9000 User Manual
Page 35
Editing the Configuration File (for a non-DHCP or UNIX Management System)
W
35
Setup Guide
10
Change the contents of the GATEWAY field to the applicable IP address,
and save and exit the file.
Note:
If you are using a direct connection (private network), leave the
GATEWAY address as 0.0.0.0.
11
Remove the REO SoftKey from the system by doing the following:
a
Double-click the Unplug or Eject Hardware icon, located in the
system tray (lower-right corner of the task bar).
b
In the Unplug or Eject Hardware dialog box, select the device you
want to unplug (the key is identified as USB Mass Storage Device),
and click Stop.
c
In the Stop a Hardware device dialog box, select USB Mass
Storage Device, and then click OK.
d
When the message appears that indicates it is safe to remove the
device, click OK, and remove the REO SoftKey.
12
Complete the steps outlined in the next section,
Select USB Mass Storage Device,
and then click Stop.
Select USB Mass Storage Device
again, and then click OK.