Entering the fibre channel information – Overland Storage REO 9000 User Manual
Page 56
56
X
Configuring the Management System
Overland Storage REO 9000 with ProtectionPAC Software
3
Click Apply.
4
Repeat these steps for Data Port 2 using an IP address that falls within
the Data Port 2 subnet.
Tip:
Overland Storage recommends that you use a ping command to
ensure that the management system sees each port on the REO
Appliance.
5
If you purchased the FC-enabled REO Appliance, continue the
configuration process by entering the FC information described in the
next section; otherwise, proceed to the subsequent section,
Entering the Fibre Channel Information
1
In the right pane, scroll down to the Fibre Channel Configuration
section.
2
For each FC port (the REO Appliance provides two), select the applicable
settings from the Set Link Speed and Set Link Topology lists.
For link speed, select Auto, 1 GB, or 2 GB.
For topology, select Auto, Fabric/Point-to-Point (N_Port), or Loop
(NL_Port).
3
Click Apply.
4
Continue the configuration process by configuring the system
information as described in the next section.
Select the applicable
settings for each
Fibre Channel port.