Output Solutions 650 - Manual (Page 120)

Appendix B IBM ProPrinter X24 and IBM ProPrinter II Commands
ESC J n (IBM ProPrinter X24)
One Line Feed of n/216" or n/180" Hexadecimal code: 1B 4A n
n = 1 - 255
Prints the buffer and feeds the paper line feed.If the parameter AGM : NO has been
selected in the SETUP , the paper line feed by n/216"; If the parameter AGM : YES has
been selected in the SETUP , the paper line feed by n/180".
It also executes a carriage return, if the parameter LF + CR : YES has been selected in
the SETUP.
The value of n must be a multiple of 3 (minimum line feed). In 8-needle graphic printing,
the value 24/216" ensures that the lines meet perfectly.
ESC J n (IBM ProPrinter II)
One Line Feed of n/216" Hexadecimal code: 1B 4A n
n = 1 - 255
Prints the buffer and feeds the paper by n/216". It also executes a carriage return, if the
parameter LF + CR = YES has been selected in the SETUP.
In 8-needle graphic printing, the value 24/216" ensures that the lines meet perfectly.
ESC ]
Line Feed Backward Hexadecimal code: 1B 5D
Prints the current line and executes a line feed backward of a value determined by the
vertical spacing selected.
If the parameter LF + CR = YES has been selected from the Setup, the printing position is
set at the left margin.
ESC [ c1 c2 t1 t2 n1 n2 IBM ProPrinter X24 only
Line Feed Value Modification Hexadecimal code: 1B 5B 5C c1 t2 n1 n2
Modifies the values of codes ESC J and ESC 2 as n/ 216” or n/180”.
Parameters c1, c2, t1, t2 and n1 have the following fixed decimal values: 4, 0, 0, 0, and 0.
Parameter n2 has the decimal value: 180 or 216.
B-10