Output Solutions 650 - Manual (Page 43)

Configuring the Printer
LQ CONFIGURE
Parameter Option Explanation Note
CR+LF NO
YES
YES: CR = LF + CR
NO: CR = CR
LEFT MARG. (1/60") 0
-6 up to +6
To adjust the left margin
more to left or right in units
of 1/60" inch (about 4 mm).
TOP MARG. (1/6") 0
-1 up to +6
Adjust the top margin in
units of 1/6 inch. TOF = Top Of Form
TOP MARG. (1/60") 0
-5 up to +5
Adjust the top margin in
units of 1/60 inch (about
4 mm). TOF = Top Of Form
ZERO SLASH NO
YES
Select the printout of 0
(0x30 = zero)
YES = the 0 will be printed
with a slash on it (e.g. 0/ ).
LINE LENGTH 80
90
94
Setting the line length in
unit of character of 10 CPI.
RESET WHEN EJECT NO
YES
NO = no reset
YES = the printer will be
reset when eject a form.
PNS SELECTION NO
YES
Whether the following PNS
item is valid or not.
PNS #2100K NO
YES
YES = Reset automatically
line condensation when
Form Feed command
executed.
NO = no reset Only displayed if PNS
SELECTION is set to
YES.
PNS #2101K NO
YES
NO = ignore 0x20 at the
end of a line.
YES = don't ignores 0x20
at the end of a line. Only displayed if PNS
SELECTION is set to
YES.
PNS #2102K NO
YES
YES = Process of the
horizontal and vertical
movement command:
ESC $; ESC \; ESC (v)
NO = ignore the command Only displayed if PNS
SELECTION is set to
YES.
This PNS is only active
on ver. 1.08 or higher.
3-15