Output Solutions 650 - Manual (Page 48)

ADJUSTMENT
PHOTOSENSOR VALUE
Configuring the Printer
3.6.3 TOP MARGIN
The [FEED/EJECT •] key reduce the current value (top margin is moving upwards) and
the [COMPRESS –] key enlarge the current value (moving downwards).
After entering adjustment, you have to do the following steps:
Key or action Two line display
Select Adjustment ADJUSTMENT
PHOTOSENSOR VALUE
[COMPRESS –]
until LCD shows
ADJUSTMENT
TOP MARGIN
[STOP #] to select
Press [FEED/EJECT •] or [COMPRESS –] to find the new top margin.
The range is from zero up to 214.
TOP MARGIN 030
• = UP – = DOWN
TOP MARGIN 042
• = UP – = DOWN
Insert an A4 sheet to control the setting. The printer will insert the paper
automatically, print the current margin and eject the paper.
TOP MARGIN (042)
• = UP – = DOWN
[STOP #] to accept TOP MARGIN
SAVE PARAMETERS
Display after saving ADJUSTMENT
TOP MARGIN
3.6.4 RUN IN TEST
After selecting the Run in Test the printer will insert a sheet and start nonstop printing.
Key or action Two line display
[COMPRESS –]
until LCD shows
ADJUSTMENT
RUN IN TEST
[STOP #] to select
The yellow Ready lamp lights up.
RUN IN TEST
PLEASE INSERT SHEET
The printer starts printing horizontal lines after inserting a paper. RUN IN TEST NO: 00
printing, finish: 00
Now it is possible to stop printing by pressing the [STOP #] key. RUN IN TEST NO: 00
printing, finish: 00
[STOP #] continued printing RUN IN TEST NO: 00
printing, finish: 00
Power off the printer to leave the continued printing.
Note:
Use Bidirectional Alignment Adjust to correct an offset in the vertical lines (see
paragraph 3.6.5).
3-20
Select Adjustment
ADJUSTMENT
PHOTOSENSOR VALUE