Output Solutions 650 - Manual (Page 46)

Configuring the Printer
3.6 ADJUSTMENT
Adjustment can be used to adjust and check some built-in parameters of the printer. It may
enhance the print performance. Sometimes, it’s possible to improve the rationality of the
page layout according to the practical environment. The printer has been adjusted
corresponding to factory standard before it is delivered.
Warning: The user who wants to adjust these parameters of the printer should be a
professional engineer or be guided by a professional engineer.
User usually should not change the settings. If the printer has to be adapted, the user
should have already well understood the involved parameters. Or else the printer may
miss normal function. The following introduce the adjustable parameters.
These parameters below allow manipulation on operator panel:
• Photosensor Value (see paragraph 3.6.1)
• Left Margin (see paragraph 3.6.2)
• Top Margin (see paragraph 3.6.3)
• Run In Test (see paragraph 3.6.4)
• Alignment Adjustment for Bidirectional Printing (see paragraph 3.6.5)
• Printing Photosensor Value (see paragraph 3.6.6)
• Inquire Photosensor Values (see paragraph 3.6.7)
• Resume HW Parameters (see paragraph 3.6.8)
3.6.1 PHOTOSENSOR VALUE
All the photo sensor value has been adjusted to correct values in the factory, but after
using it for many days, some unexpected change may happen for some reason, such as
using unacceptable paper. In order to make the printer work correctly, please adjust the
photo sensor value again.
After entering adjustment, you have to do the following steps:
Key or action Two line display
Select Adjustment ADJUSTMENT
PHOTOSENSOR VALUE
[STOP #]
There is a noise of the rollers and the green lamp of Station 2 light up
PHOTOSENSOR VALUE
INSERT SHEET; PRESS
#
insert paper and press
[STOP #]
PHOTOSENSOR VALUE
INSERT SHEET; PRESS
#
The printer insert the paper and start the setup of the photo sensor.
Paper eject after adjustment.
PHOTOSENSOR VALUE
END. PRESS
#
TO PRINT
[STOP #] PHOTOSENSOR VALUE
INSERT A4 SHEET
Insert paper;
after print the values the paper will be eject
PHOTOSENSOR VALUE
FINISH; PRESS STAT 2
3-18
[STATION 2] PHOTOSENSOR VALUE