Output Solutions 650 - Manual (Page 142)

Appendix B IBM ProPrinter X24 and IBM ProPrinter II Commands
ESC 6
Table 2 of Character Set Hexadecimal code: 1B 36
Selects table 2 of the character set with the complete set of national characters (default
setting).
It takes priority over the setting made in the SETUP.
ESC 7
Table 1 of Character Set Hexadecimal code: 1B 37
Selects table 1 of the character set (see the Command Interpreter and Character Sets
section), which repeats the control codes in the code positions 128-159.
It takes priority over the setting made in the SETUP.
ESC \ n1 n2
Print Characters from Table 3 Hexadecimal code: 1B 5C n1 n2
Enables printing of the symbols present in the positions that normally represent control
codes.
This command tells the printer to ignore the function of the commands for the codes
between 0 and 32 (and, with table 1 selected, also between 128 and 159) and to print the
substitute symbols present in these positions.
Parameters n1 and n2 indicate the number of characters to be printed in this way. They
are calculated as follows:
n2 = whole number (number of data items/256)
n1 = number of data items - (n2 x 256)
Having printed the number of symbols determined by parameters n1 and n2, the printer
resumes normal operation using the preselected character set (table 1 or 2). The function
of control codes 0-32 (and 128-158) is restored and the function of this command ceases.
ESC ^
Print a Character from Table 3 Hexadecimal code: 1B 5E
Has the same function as the command ESC \ .., but only enables one character to be
printed, the one that follows the command.
B-32