Output Solutions 650 - Manual (Page 35)

Configuring the Printer
CONFIGURE
Parameter Option Explanation Note
MODIFY RS1 CONFIG NO
YES
If YES configure also baud
rate, bits/character, parity
and stop bit.
NO not used with
CX EMULATION .
BAUD RATE (RS1) 2400
4800
9600
19200
Controls the speed of the
data transfer.
The baud rate for the
printer should be
corresponding to the
settings of the computer. Only displayed if
MODIFY RS1
CONFIG
is set to YES
BITS/CHARACTER (RS1) 87 Number of bits that
represent a character.
Only displayed if
MODIFY RS1
CONFIG
is set to YES
PARITY (RS1) NONE
EVEN
ODD
The data transfer will be
checked by an even or odd
parity bit. Only displayed if
MODIFY RS1
CONFIG
is set to YES
STOP BITS (RS1) 12 Number of stop bits which
are in use.
Only displayed if
MODIFY RS1
CONFIG
is set to YES
DSR (RS1) NO
YES
SERIAL 1 handle the DSR
signal or not. Only displayed if
MODIFY RS1
CONFIG
is set to YES
CX EMULATION IBM
LQ 1600K
The emulation determines
the set of commands
available for the printer:
CX STROBE EDGE RISING EDGE
FALLING EDGE
Select the trig mode of the
printer strobe signal (CX
present.
DRAFT SPEED NORMAL
HIGH SPEED
Select printer speed in draft
mode.
LQ TYPE
NLQ1
NLQ2
Select the printer type in
LQ mode.
NEEDLES SWITCH YES
NO
YES = activated
No = ignored
3-7