Output Solutions 650 - Manual (Page 52)

Configuring the Printer
3.6.8 RESUME HARDWARE PARAMETERS
All standard default settings of the firmware will be restored. The contents of the page
counter will not be changed, but all other settings are reset.
[COMPRESS –]
until the LCD shows:
ADJUSTMENT
RESUME HW PARAMETERS
[STOP #] to select
The yellow Ready and green Station 1 and Station 2 lamp lights up.
RESUME HW PARAMETERS
#
ACCEPT ST2 = IGNORE
If you want to leave the off-line mode press [STATION 2] and
[COMPRESS –] together.
SAVE PARAMETERS
#
ACCEPT ST2 = IGNORE
*) The displayed line is depending on the selected emulation.
3.7 DEBUG / TEST
The Debug / Test parameter defines the execution of control sequences when Hex-
printing has been activated. The incoming or stored data from the host are printed in hex
mode. This is an excellent help for the programmer.
The Debug/ Test mode is arrange into two groups:
• Hex Printing
• Magnetic Test
In the Hex Printing mode we will find five groups:
• Data Backup Mode
• Printing Saved Data
• Printing Last Data
• Printing Flash Data
• Directly Dump
The HEX print is divided into three groups:
• 1. the transmission code first with five bytes
• 2. values of the data in HEX
• 3. ASCII code of the printed data
1. 2. 3.
Sample: 00000 00 0C 07 0D 07 0D 07 0D 07 0D 07 0D 0 & C * C * C * C * C *
3-24
Key or action Two line display
Select Adjustment ADJUSTMENT
PHOTOSENSOR VALUE
Press [STATION 2] to ignore.
Press[STOP #] to accept
or [STATION 2] to ignore.
ADJUSTMENT
RESUME HW PARAMETERS
OFF-LINE MODE
ADJUSTMENT
CX LQ1600K
ON-LINE