Output Solutions 650 - Manual (Page 32)

Configuring the Printer
3.2.1 Explanation of the Printout on the Previous Pages
In the headline behind the term VER2 the revision level of the printer's firmware can be
found.
Then following the Printer Identification and in the next line a needle test.
The next part of the printout is a list of the MACRO settings.
In this case MACRO 1 is marked with an asterisk (*) which identifies it as the active
macro.
Note:
A “Macro“ is a summary of application specific parameter settings for a user. It is
possible to have a total of three macros, each with a different summary of VALUE
settings for different applications.
Whenever you make modifications in the active macro without saving them you will find
the new settings under the heading CURRENT USER. Unless they are saved, the
modifications will stay active only until the printer is switched off. When the printer is
switched on again the macro settings marked with the asterisk will be reactivated.
Note:
The CURRENT USER will be selected by MACRO 1, MACRO 2, or MACRO 3.
3.3 Menu Structure
Press [STATION 2] and [COMPRESS –] together to start the Menu-Mode in Off-line
operation.
The Menu Mode starts with MENU SETUP in level 1.
3-4
OFF-LINE MODE
Printing
Test
Menu
Printing
Menu
Setup
Debug/Test Info
Inquiring
Select Current Macro
Select User to Setup
Configure
IBM Configure
LQ Configure
Save Parameters User’s Guide
ASCII Character Set
Character Attributes
Dr. Grauert Photo Sensor Value
Left Margin
Top Margin
Run In Test
Bidirectional Aligment
Print Photo Values
Inquire Photo Values
Resume Hardware
Parameters Data Backup Mode
Printing Saved Data
Printing Last Data
Printing Flash Data
Directly Dump FW Version
HW Version
Printer ID
Level 1
Level 2