Texas Instruments PLUS TI-89 - Manual (Page 12)

x
Flash Applications
Flash functionality enables the ability to download different
applications to a
TI -89 / TI-92 Plus calculator from the enclosed
CD-ROM, the TI web site, or from another calculator.
Before downloading new applications to a TI -89 / TI-92 Plus , please
read and accept the license agreement on the TI -89 / TI-92 Plus
Applications CD-ROM.
Before installing Flash applications, you will need:
•
A computer with a CD-ROM drive and a serial port.
•
TI™ Connect or TI-GRAPH LINK™ software and a TI-GRAPH LINK
cable. If you need the TI Connect/ TI-GRAPH LINK software or a
TI-GRAPH LINK cable, check the TI web site at education.ti.com .
To set up:
1. Insert the small end of the TI-GRAPH LINK cable into the port at
the bottom of the TI -89 or the top of the TI -92 Plus .
2. Connect the other end to the computer’s serial port using a
25-to-9 pin adapter if necessary.
To install an application:
1. Insert the TI -89 / TI-92 Plus Applications CD-ROM into the
computer’s CD-ROM drive.
2. From the computer, start the TI-GRAPH LINK software.
3. From the Link menu, click Send Flash Software 8 Applications and
Certificates .
4. Locate the Flash application on the CD-ROM and double-click.
The Flash application is copied to the calculator.
To run an application:
1. On the TI -89 / TI-92 Plus , press ¥ O to display the FLASH
APPLICATIONS menu.
2. Use the cursor keys CD to highlight the application and press
¸.
Applications
Hardware/Software
Requirements
Hardware Setup for
the Computer
Installing a Flash
Application from the
CD-ROM
Note: For further
information about
transmitting applications to
and from your computer
using TI Connect, refer to
the TI Connect online help.
Running a Flash
Application