Texas Instruments PLUS TI-89 - Manual (Page 186)

Chapter 10: 3D Graphing 169
10_3D.DOC TI-89/TI-92 Plus: 3D Graphing (English) Susan Gullord Revised: 02/23/01 11:00 AM Printed: 02/23/01 4:22 PM Page 169 of 22
From the Graph screen, display the Draw menu and then select
8:DrwCtour . The Home screen is displayed automatically with
DrwCtour in the entry line. You can then specify one or more z values
individually or generate a sequence of z values.
Some examples are:
DrwCtour 5
DrwCtour {1,2,3}
DrwCtour seq(n,n, ë 10,10,2)
The specified contours are drawn on the current 3D graph.
(A contour is not drawn if the specified z value is outside the viewing
cube or if the 3D graph is not defined at that z value.)
For a contour plot:
¦ You can use the cursor keys (page 164) to animate the contour
plot.
¦ You cannot trace ( … ) the contours themselves. However, you
can trace the wire frame as seen when Style=WIRE AND
CONTOUR .
¦ It may take awhile to evaluate the equation initially.
¦ Because of possible long evaluation times, you first may want to
experiment with your 3D equation by using
Style=WIRE FRAME .
The evaluation time is much shorter. Then, after you’re sure you
have the correct Window variable values, display the Graph
Formats dialog box and set
Style=CONTOUR LEVELS or WIRE
AND CONTOUR .
TI
-
89: ¥ Í
TI
-
92 Plus : ¥ F
Drawing Contours
for Specified Z
Values
Tip: To remove the default
contours, use
¥ $ and set
ncontour=0 .
Notes about
Contour Plots
Draws a contour for z=5.
Draws contours for z=1, 2, and 3.
Draws contours for a sequence of z
values from
ë 10 through 10 in
steps of 2 ( л 10, л 8, л 6, etc.).