Texas Instruments PLUS TI-89 - Manual (Page 247)

230 Chapter 13: Tables
13TABLES.DOC TI-89/TI-92 Plus: Tables (English) Susan Gullord Revised: 02/23/01 1:08 PM Printed: 02/23/01 2:16 PM Page 230 of 10
1. Move the cursor to highlight any cell in the independent variable
column.
2. Press † to move the cursor to the entry line.
3. Type a series of values, enclosed in braces { } and separated by
commas. For example:
x={1,1.5,1.75,2}
You can also enter a list variable or an expression that evaluates
to a list.
4. Press ¸ to move the values into the independent variable
column. The table is updated to show the corresponding function
values.
To: Do this:
Insert a new row
above a specified row Highlight a cell in the specified row and
press:
TI-89: 2 ˆ
TI-92 Plus: ˆ
The new row is undefined ( undef ) until you
enter a value for the independent variable.
Delete a row Highlight a cell in the row and press ‡.
If you highlight a cell in the independent
variable column, you can also press 0.
Clear the entire table
(but not the selected
Y= functions) Press ƒ 8 . When prompted for
confirmation, press ¸.
Several factors affect how numbers are displayed in a table. Refer to
“Changing the Cell Width” and “How Numbers Are Displayed in a
Cell” on page 227.
System variable tbl Z nput contains a list of all independent variable
values entered in the table, even those not currently displayed.
tbl Z nput is also used for an automatic table, but it contains only the
independent variable values that are currently displayed.
Before displaying a table, you can store a list of values directly to the
tbl Z nput system variable.
Entering a List in
the Independent
Variable Column
Note: If the independent
variable column contains
existing values, they are
shown as a list (which you
can edit).
Adding, Deleting,
or Clearing
Cell Width and
Display Formats
From the Home
Screen or a Program